Hardware Support > ICC-5200/6200/7200

Hardware Support: ICC-5200/6200/7200 Series

The documentation, software, and support information on this page applies only to the ICC-5200/6200/7200 Series with the American Megatrends’ Merlin PCI motherboard. To find another product, please return to Hardware Support.

For additional support information regarding video and touchscreen performance, peripherals, and system utilities, be sure to check our ICC Family general issues page.

Documentation
User Manual: ICC-5200/6200 Series Industrial Control Computer™ (DOC-IWS-464E) 0.6 MBPDF icon
User Manual: ICC-7000/7100/7200 Series (DOC-IWS-495C) 0.7 MBPDF icon
User Manual: Merlin PCI Motherboard Guide (DOC-IWS-494) 0.5 MBPDF icon

Frequently Asked Questions

  1. What is the fastest processor I can put in it?
  2. How much RAM memory will it support?
  3. I've forgotten my BIOS password. How can I make changes?

What is the fastest processor I can put in it?

The motherboard will support a Pentium Pro up to 200MHz. Caution should be taken to ensure the correct voltage jumper configuration to prevent damage upon power up. Refer to the Merlin PCI Motherboard Guide for more information.

How much RAM memory will it support?

It will support from (2) 4 Mb, or (4) 2Mb (minimum 8Mb) to (4) 16Mb SIMMs (maximum 64Mb). There are (2) banks of (2) slots. Both slots within a bank must contain the same type and size of 72-pin, Fast Page or EDO, parity or non-parity, 70ns or faster SIMM. The two banks can contain different sizes and speeds, but the parity must match, and the speed must be specified in the BIOS setup.

I've forgotten my BIOS password. How can I make changes?

There is a place to insert a jumper on the motherboard to erase CMOS RAM. Turn power off, and install jumper at J33. Turn on power for about 10 seconds. Turn off power and remove jumper. Turn on power and run Setup to re-configure.

Remember, if you didn’t find the answer here, check the ICC Family general issues page!