Hardware Support > ICC-5300/6300/7300

Hardware Support: ICC-5300/6300/7300 Series

The documentation, software, and support information on this page applies only to the ICC-5300/6300/7300 Series with American Megatrends’ Atlas PCI III motherboard. To find another product, please return to Hardware Support.

For additional support information regarding video and touchscreen performance, peripherals, and system utilities, be sure to check our ICC Family general issues page.

Documentation
User Manual: ICC-x300/x400/x500/x600 Series (DOC-IWS-525B) 1.0 MBPDF icon
User Manual: Atlas PCI III Motherboard Guide (DOC-IWS-520) 0.8 MBPDF icon
Document: Atlas BIOS Settings 0.1 MB

Frequently Asked Questions

  1. What is the fastest processor I can put in it?
  2. How much RAM memory will it support?
  3. I've forgotten my BIOS password. How can I make changes?

What is the fastest processor I can put in it?

The motherboard will support a Pentium Classic 233MMX. Caution should be taken to ensure the correct voltage jumper configuration to prevent damage upon power up. Refer to the Atlas PCI III Motherboard Guide for more information.

How much RAM memory will it support?

It will support from (2) 1 Mb to (4) 32Mb SIMMs (maximum 128Mb). There are (2) banks of (2) slots. Both slots within a bank must contain the same type and size of 72-pin, Fast Page or EDO, parity or non-parity, 60ns or faster SIMM. The two banks can contain different sizes and speeds, but the parity must match, and the parity must be specified or disabled in the BIOS setup.

I've forgotten my BIOS password. How can I make changes?

There are two pins on the motherboard used to erase NVRAM. Turn power off, and short the J18 pins together for about 2 seconds. Remove short, turn power on and run Setup to re-configure. Refer to the document "Atlas BIOS Settings" for instructions on how to restore Nematron default settings.

Remember, if you didn’t find the answer here, check the ICC Family general issues page!