Hardware Support > ICC-5400/6400/7400

Hardware Support: ICC-5400/6400/7400 Series

The documentation, software, and support information on this page applies only to the ICC-5400/6400/7400 Series with American Megatrends’ Pegasus motherboard. To find another product, please return to Hardware Support.

For additional support information regarding video and touchscreen performance, peripherals, and system utilities, be sure to check our ICC Family general issues page.

Documentation
User Manual: ICC-x300/x400/x500/x600 Series (DOC-IWS-525B) 1.0 MBPDF icon
User Manual: Pegasus Motherboard Guide (DOC-IWS-521) 0.6 MBPDF icon
Document: Pegasus BIOS Settings 0.1 MB

Frequently Asked Questions

  1. What is the fastest processor I can put in it?
  2. How much RAM memory will it support?
  3. I've forgotten my BIOS password. How can I make changes?

What is the fastest processor I can put in it?

The motherboard will support a Pentium II or Celeron up to 333 MHz. Caution should be taken to ensure the correct voltage jumper configuration to prevent damage upon power up. Refer to the Pegasus Motherboard Guide for more information.

How much RAM memory will it support?

The motherboard contains (3) banks of (2) slots each. Both slots within a bank must contain the same type and size of 72-pin, Fast Page or EDO, parity or non-parity, 60ns or faster SIMM. The minimum is (2) 4Mb SIMMs, or 8Mb, and the maximum is (6) 128Mb SIMMs, or 768Mb.

I've forgotten my BIOS password. How can I make changes?

There are two pins on the motherboard used to erase CMOS RAM. Turn power off, and short the J29 pins together for about 5 seconds. Turn power on and run Setup to re-configure. Refer to the document "Pegasus BIOS Settings" for instructions on how to restore Nematron default settings.

Remember, if you didn’t find the answer here, check the ICC Family general issues page!