![]()
Hardware Support > ICC-5500/6500/8500
The documentation, software, and support information on this page applies only to the ICC-5500/6500/8500 Series with American Predator’s Raptor AT motherboard. To find another product, please return to Hardware Support.
For additional support information regarding video and touchscreen performance, peripherals, and system utilities, be sure to check our ICC Family general issues page.
| Documentation | |
| Datasheet: ICC-5500/6500/8500 Industrial Control Computer™ | 1.1
MB![]() |
| User Manual: ICC-x300/x400/x500/x600 Series (DOC-IWS-525B) | 1.0
MB![]() |
| User Manual: Raptor AT Motherboard Guide (DOC-IWS-598) | 0.2
MB![]() |
| Document: Raptor BIOS Settings | 0.1 MB |
The Rev. A motherboard will support a Socket 370 Celeron up to 433 MHz. Rev. B motherboard will support Celeron 566MHz and Pentium III Socket 370 up to 700MHz. Caution should be taken to ensure the correct voltage jumper configuration to prevent damage upon power up. Refer to the Raptor AT Motherboard Guide for more information.
The Raptor AT offers 3 DIMM memory sockets. They can be configured with 3.3V unbuffered SDRAM modules.
There is a jumper setting on the motherboard used to reset CMOS RAM. (Jumper JP5 is near the EIDE connectors close to the CPU). Turn power off, and move the jumper from JP5 pins 1 and 2 to pins 2 and 3, turn the system on, move jumper to 1-2 and press reset. Run Setup to re-configure. Refer to the document "Raptor BIOS Settings" for instructions on how to restore Nematron default settings.
Yes. Nematron offers a variety of ISA and PCI cards for this purpose.
Remember, if you didn’t find the answer here, check the ICC Family general issues page!